Description The clamp sleeve is designed for mounting on the rifle scope. It is pushed over the lens of the rifle scope over a length of 40 mm (or 35 mm for diameters of 30 to 36 mm) and screwed into place. It remains permanently on the rifle scope. For installation, 4 mm of space is required between the rifle scope and the barrel, and our clamping sleeve adds 3.5 mm. For extremely flat rifle scopes, we offer a “Low Scope” clamping sleeve with a diameter of 62 mm. This has a milled recess towards the barrel root. The total diameter for clamping sleeves up to 61mm lens diameter is 65mm at the locking ring. A protective film is applied to the contact surfaces of the clamp sleeve and the rifle scope lens, which prevents damage to the rifle scope and increases adhesion to the rifle scope. This means that the clamp sleeve and therefore also the attachment device will not be pulled off the rifle scope, even with strong calibers. A special inner contour ensures that the attachment is precisely aligned with the rifle scope. The bayonet on the front of the clamping sleeve is the basis for absolutely repeatable alignment of an attachment every time it is reattached. Our clamping sleeve is made from a single piece of high-quality aluminum and is protected against corrosion and wear by a hard anodized layer. We expressly point out that an attachment may only be mounted on the weapon if the legislation of the respective country allows it. The installation is at your own risk. Technical data material high-quality aluminum surface black anodized wall thickness 3 mm
